Concave - A
90 degree concave tip for probing wire-wrap terminals, connector pins, component leads and feed through terminals.
Flat - F
Used for damage free probing of rounded surfaces. Also suitable for solder pads and contact pins.
Spear - B
For penetration of oxides, fluxes and some conformal coatings. Also used to contact solder pads and holes.
Star - K
Through-plated holes, lands and pads. Self cleaning sharp point. The sharp edges penetrate contamination and oxide layers.
Dagger - BT80 & Chisel - H
Used to penetrate holes and solder pads. The sharp edges penetrate flux residues and oxide layers.
Crown - Q & L
For pad surfaces and soldered pins. The sharp edges penetrate flux residues and oxide layers.
Serrated - C
Sharp points provide good electrical contact over large target areas, for example bent component leads, without deflection.
Insulated Serrated - C.INS
For detecting the correct length and straightness of pins.
Dome - D
For screws, terminal blocks and edge connector fingers. Does not leave marks or scratches.
Tulip - M1
Used for severe contacting of plated and through holes.